In the text properties box, the alignment selections don't work.

  • 1
  • Problem
  • Updated 2 years ago
After converting from Cam 2 to Cam 3 some of the text is not aligned correctly. I tried realigning it using the text alignment in the Properties panel but the text doesn't respond. It stays centered both horizontally and vertically. Then I tried it with newly created text and still I can't change the alignment. 

Can you fix this, or tell me what I'm doing wrong?
Photo of training

training

  • 118 Posts
  • 41 Reply Likes

Posted 2 years ago

  • 1
Photo of Paul Middlin

Paul Middlin, Employee

  • 835 Posts
  • 185 Reply Likes
Hi, I just tested this myself, and I see that vertical alignment is definitely broken on Legacy Callouts (callouts from v2). Horizontal alignment works for me, though- which callout are you using?

In the mean time, you're kind of stuck with either vertically centered text, or using one of the new callouts :(
Photo of training

training

  • 118 Posts
  • 41 Reply Likes
The file imported had some text aligned left, but it showed up aligned center. It was OK for most of them to be centered, but some had left-aligned topic/title, with the bullets below indented, so leaving them centered didn't look right. I think I had to recreate the callout. 
(Edited)